Engine Oil Level Sensor Circuit [06/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT ENGINE OIL LEVEL SENSOR
- Remove the engine oil level sensor.
Refer to REMOVAL [06/2018 - ]
- Inspect the engine oil level sensor.
Refer to INSPECTION [06/2018 - ]
Result
Proceed to OK NG
Result:
NG
REPLACE ENGINE OIL LEVEL SENSOR. Refer to REMOVAL [06/2018 - ]
Result:
OK
See step 2
- Remove the engine oil level sensor.
- CHECK HARNESS AND CONNECTOR (ENGINE OIL LEVEL SENSOR - COMBINATION METER ASSEMBLY)
- Disconnect the G17 combination meter assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C22-1 - G17-15 (OILW) Always Below 1 Ω C22-1 or G17-15 (OILW) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [06/2018 - 08/2021] , or refer to REMOVAL [08/2021 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR