Installation [08/2020 - ]: Procedure

INSTALL OIL PRESSURE AND TEMPERATURE SENSOR

Apply adhesive to the area shown in the illustration.

Adhesive

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Do not apply adhesive to the oil inlet port of the oil pressure and temperature sensor.
Apply the adhesive to the first 3 threads or more of the oil pressure and temperature sensor.
Apply adhesive to the entire circumference of the thread.
To prevent contamination by foreign matter, install immediately after applying adhesive.

Using a 24 mm deep socket wrench, install the oil pressure and temperature sensor.
Torque: 15 N.m (153 kgf/cm, 11 ft.lbf)

NOTE:
Do not start the engine within 1 hour of installation.
Connect the oil pressure and temperature sensor connector.

INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 6 [08/2021 - ]
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 71 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 72 [08/2021 - ]
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 72 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 73 [08/2021 - ]
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 73 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 74 [08/2021 - ]
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 74 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 75 [08/2021 - ]