Caution / Notice / Hint
NOTE:
- After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Refer to UTILITY [06/2018 - ]
- After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Refer to TEST MODE PROCEDURE [06/2018 - 08/2020] , or refer to TEST MODE PROCEDURE [08/2020 - ]
- After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Refer to TEST MODE PROCEDURE [06/2018 - 08/2020] , or refer to TEST MODE PROCEDURE [08/2020 - ]
- DTC precaution
Refer to PRECAUTION [06/2018 - 08/2021] , or refer to PRECAUTION [08/2021 - 09/2022] , or refer to PRECAUTION [09/2022 - ]
PROCEDURE TO CLEAR WARNING LIGHTS (WHEN NOT CLEARING DTCS)Procedure - Repair or replacement.
- Turn the engine switch on (IG).
- Drive the vehicle at 11 km/h (7 mph) or more for 1 second or more to clear the warning lights.