Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake pedal support assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Perform steering sensor zero point calibration	Lane Tracing Assist System	Refer to INITIALIZATION [08/2021 - ]
		Pre-collision System
		Parking Support Brake System*
		Lighting System
	Initialize power trunk lid system	Power Trunk Lid System	Refer to INITIALIZATION [06/2018 - ]

*: When performing learning using the Techstream.

NOTE:

After the engine switch is turned off, the audio and visual system records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 2 minutes before disconnecting the cable from the negative (-) battery terminal.
When the cable is disconnected from the negative (-) battery terminal and the security lock setting has been enabled, multi-display operations will be disabled upon next startup unless the password is entered. Be sure to check the security lock setting before disconnecting the cable from the negative (-) battery terminal.