LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 250h Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Continuously Variable Transaxle (CVT) System (K120) (Service Information) (2 Of 2)) >> Shift Paddle Switch >> Installation [10/2018 - 07/2022] >> Procedure

Installation [10/2018 - 07/2022]: Procedure

WARNING: This page is about a different car, the 2022 Lexus UX 200, 2021 Lexus UX 200, 2020 Lexus UX 200, and 2019 Lexus UX 200. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL NO. 1 SWITCH WIRE 

    HINT: 

    Perform this procedure only when replacement of the No. 1 switch wire is necessary.

    1. Engage the 4 guides to install the No. 1 switch wire to the steering wheel assembly.
  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) 
    1. Connect the 2 shift paddle switch (transmission shift switch assembly) connectors to install the 2 shift paddle switches (transmission shift switch assemblies) to the No. 1 switch wire.
    2. Engage the 2 clamps.
    3. Engage the 4 claws to install the 2 shift paddle switches (transmission shift switch assemblies) to the steering wheel assembly.
      NOTE:

      Make sure that the junction of the No. 1 switch wire is the right of the guide as shown in the illustration.

      GTY815648Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a No. 1 Switch Wire
    4. Install 2 new screws.

      Torque: 1.7 N.m (17 kgf/cm, 15 in.lbf) 

  3. INSTALL STEERING PAD SWITCH ASSEMBLY 

    Refer to INSTALLATION [10/2018 - ]

  4. INSTALL STEERING WHEEL ASSEMBLY 

    Refer to INSTALLATION [10/2018 - 07/2022]

scientia non olet · About LEMON Manuals