LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 250h Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Continuously Variable Transaxle (CVT) System (K120) (Service Information) (2 Of 2)) >> Combination Switch >> Removal [10/2018 - 07/2022] >> Procedure

Removal [10/2018 - 07/2022]: Procedure

WARNING: This page is about a different car, the 2022 Lexus UX 200, 2021 Lexus UX 200, 2020 Lexus UX 200, and 2019 Lexus UX 200. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE METER HOOD SUB-ASSEMBLY 

    Refer to REMOVAL [10/2018 - 07/2022]

  2. REMOVE COMBINATION SWITCH ASSEMBLY (SATELLITE SWITCH SET) 
    1. Disengage the clamp to disconnect the wire harness from the meter hood sub-assembly.
      GTY798562Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the combination switch assembly (satellite switch set) connector.
    3. Remove the 3 screws and combination switch assembly (satellite switch set) from the meter hood sub-assembly.
      GTY798572Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 3 claws and guide to remove the No. 2 instrument panel hole cover from the meter hood sub-assembly.
      GTY798571Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals