Installation [10/2018 - 07/2022]: Procedure

HINT: 

When reusing the fan and generator V belt, check the ribs and back of the fan and generator V belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the fan and generator V belt.

1. Set the fan and generator V belt onto each pulley as shown in the illustration.
   Fig 1: Drive Belt Routing

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Crankshaft Pulley Assembly
   *2	Generator Assembly
   *3	Compressor with Pulley Assembly

2. Turn the V-ribbed belt tensioner assembly clockwise and remove the 5 mm hexagon wrench.
3. After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley by hand.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Correct
   *b	Incorrect

1. Install the rear engine under cover RH to the vehicle with the 2 screws and 6 clips.