LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Electronically Controlled Brake System (Diagnostic Codes (4 Of 4) & Circuit Tests) (Hybrid)) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) >> Brake Actuator Operation Sound is Loud during Initial Check [10/2018 - ] >> Procedure

Brake Actuator Operation Sound is Loud during Initial Check [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM ROAD TEST 
    1. After turning the power switch on (READY), compare the operating sound of the brake actuator the first time the vehicle speed reaches approximately 25 km/h (16 mph) with a known good vehicle of the same model.

      OK

      The operating sound is the same or quieter than that of a known good vehicle of the same model.

      HINT: 

      When the vehicle speed reaches approximately 20 km/h (12 mph), the initial check of the brake actuator assembly is performed and pump motor operation sounds are generated.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END 

    Result: 

    NG 

    See step  2

  2. CHECK BRAKE ACTUATOR BOLT CUSHION 
    1. Check that the cushion of the brake actuator bracket assembly is not worn, damaged or deformed.

      OK

      The brake actuator bracket assembly is not worn, damaged or deformed.

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE BRAKE ACTUATOR BOLT CUSHION 

    Result: 

    OK 

    See step  3

  3. ADJUST INSTALLATION OF BRAKE ACTUATOR ASSEMBLY 
    1. Drain the brake fluid.
    2. Disconnect all brake lines from the brake actuator assembly.

      Refer to REMOVAL [10/2018 - 07/2022] , or refer to REMOVAL [07/2022 - ]

    3. Connect each brake line so that the cushion of the brake actuator assembly is tensioned evenly.

      Refer to INSTALLATION [10/2018 - 07/2022] , or refer to INSTALLATION [07/2022 - ]

      NOTE:

      After connecting all the brake lines, add brake fluid and bleed the brake system.

      Refer to BLEEDING [10/2018 - ]

      HINT: 

      By reducing the tension on the brake lines and cushion, the operating sound of the brake actuator assembly may be reduced.

    4. Check that no brake lines interfere the vehicle body or other components.

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  4

  4. RECHECK SYMPTOM 
    1. Perform a road test and check the magnitude of the operating sound again.

      OK

      The operating sound is the same or quieter than that of a known good vehicle of the same model.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END 

    Result: 

    NG 

    REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to  REMOVAL [10/2018 - 07/2022]  , or refer to  REMOVAL [07/2022 - ]