LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Can Communication System (Symptom Tests) (2 Of 3) (Hybrid)) >> CAN COMMUNICATION SYSTEM (for HV Model) >> Open in One Side of Bus 2 Branch Line [10/2018 - 10/2019] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

    Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2018 - ]

  • After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.

    DTC check procedure: Turn the power switch on (IG) and wait for 1 minute or more. Then operate the suspected malfunctioning system and drive the vehicle at 60 km/h (37 mph) or more for 5 minutes or more.

  • After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed as normal.

    Refer to DIAGNOSIS SYSTEM [10/2018 - 10/2019]

  • Before replacing the hybrid vehicle control ECU, refer to Registration.

    Refer to REGISTRATION [10/2018 - 10/2019]

scientia non olet · About LEMON Manuals