LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Can Communication System (Diagnostic Codes & Symptom Tests (1 Of 3)) (Hybrid)) >> CAN COMMUNICATION SYSTEM (for HV Model) >> Door Mirror ECU RH Communication Stop Mode [10/2018 - ] >> Procedure

Door Mirror ECU RH Communication Stop Mode [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR OPEN IN CAN BUS LINES (OUTER MIRROR CONTROL ECU ASSEMBLY RH BRANCH LINE) 
    1. Disconnect the cable from the negative (-) auxiliary battery terminal.
    2. Disconnect the outer mirror control ECU assembly RH connector.
    3. Measure the resistance according to the value(s) in the table below.
      GTY811417Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Outer Mirror Control ECU Assembly RH)

      Standard Resistance

      Tester Connection Condition Specified Condition
      J11-9 (CANP) - J11-8 (CANN) Cable disconnected from negative (-) auxiliary battery terminal 54 to 69 Ω

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE CAN BRANCH LINES OR CONNECTOR (OUTER MIRROR CONTROL ECU ASSEMBLY RH) 

    Result: 

    OK 

    See step  2

  2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      J11-7 (GND) - Body ground Cable disconnected from negative (-) auxiliary battery terminal Below 1 Ω
      GTY835221Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Outer Mirror Control ECU Assembly RH)
    2. Reconnect the cable to the negative (-) auxiliary battery terminal.
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Switch Condition Specified Condition
      J11-5 (SIG) - Body ground Power switch on (IG) 11 to 14 V
      J11-6 (CPUB) - Body ground Power switch off 11 to 14 V
      J11-14 (BDR) - Body ground .Power switch off 11 to 14 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY RH. Refer to  REMOVAL [10/2018 - ] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) 

scientia non olet · About LEMON Manuals