Removal [07/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.

PRECAUTION
NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [07/2022 - ]
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to REMOVAL [07/2022 - ]

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [07/2022 - ]

REMOVE NO. 1 RELAY BLOCK COVER

Disengage the claws to remove the No. 1 relay block cover.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE NO. 1 INTEGRATION RELAY

Using a screwdriver with its tip wrapped in protective tape, disengage the claws.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Protective Tape

Pull up the No. 1 integration relay.
NOTE:
When pulling the No. 1 integration relay, take care not to damage it.

Disconnect the 2 connectors to remove the No. 1 integration relay.

NOTE:

When pulling the No. 1 integration relay, take care not to damage it.