DTC P3011-00: Hybrid/EV Battery Block 1 Circuit Resistance Out of Range (Extreme); DTC P30111E: Hybrid/EV Battery Block 1 Circuit Resistance Out of Range; DTC P301200: Hybrid/EV Battery Block 2 Circuit Resistance Out of Range (Extreme); DTC P30121E: Hybrid/EV Battery Block 2 Circuit Resistance Out of Range; DTC P301300: Hybrid/EV Battery Block 3 Circuit Resistance Out of Range (Extreme); DTC P30131E: Hybrid/EV Battery Block 3 Circuit Resistance Out of Range; DTC P301400: Hybrid/EV Battery Block 4 Circuit Resistance Out of Range (Extreme); DTC P30141E: Hybrid/EV Battery Block 4 Circuit Resistance Out of Range; DTC P301500: Hybrid/EV Battery Block 5 Circuit Resistance Out of Range (Extreme); DTC P30151E: Hybrid/EV Battery Block 5 Circuit Resistance Out of Range; DTC P301600: Hybrid/EV Battery Block 6 Circuit Resistance Out of Range (Extreme); DTC P30161E: Hybrid/EV Battery Block 6 Circuit Resistance Out of Range; DTC P301700: Hybrid/EV Battery Block 7 Circuit Resistance Out of Range (Extreme); DTC P30171E: Hybrid/EV Battery Block 7 Circuit Resistance Out of Range; DTC P301800: Hybrid/EV Battery Block 8 Circuit Resistance Out of Range (Extreme); DTC P30181E: Hybrid/EV Battery Block 8 Circuit Resistance Out of Range; DTC P301900: Hybrid/EV Battery Block 9 Circuit Resistance Out of Range (Extreme); DTC P30191E: Hybrid/EV Battery Block 9 Circuit Resistance Out of Range; DTC P302000: Hybrid/EV Battery Block 10 Circuit Resistance Out of Range (Extreme); DTC P30201E: Hybrid/EV Battery Block 10 Circuit Resistance Out of Range [10/2018 - ]: Procedure
- CHECK DTC OUTPUT (HYBRID CONTROL)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
- Check for DTCs.
Powertrain > Hybrid Control > Trouble Codes
Result
Result Proceed to "P0AFC00, P0AFC96, P308A12 or P0AFC62" is not output. A "P0AFC00, P0AFC96, P308A12 or P0AFC62" is also output. B - Turn the power switch off.
Result:
B
GO TO DTC CHART (HYBRID CONTROL SYSTEM). Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2018 - ]
Result:
A
See step 2
- CHECK FREEZE FRAME DATA
See step 5
Result
Result Proceed to On the HV battery blocks 3 to 7, one of the conditions in the table above is met. A Other than above B Result:
B
See step 5
Result:
A
See step 3
- CHECK TOTAL DISTANCE DRIVEN
- Read the odometer to check the total distance the vehicle has been driven.
Result
Result Proceed to Total distance driven is less than 200000 km (124280 mile) A Total distance driven is 200000 km (124280 mile) or more Current total distance driven - total distance driven when hybrid battery terminal block replaced = less than 200000 km (124280 mile) *1 Other than above B HINT:
*1: If the hybrid battery terminal block has been replaced, use the total distance driven since it was replaced.
Result:
A
REPLACE HV BATTERY. Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]
Result:
B
See step 4
- Read the odometer to check the total distance the vehicle has been driven.
- REPLACE HV BATTERY
Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]
Result
Proceed to NEXT Result:
NEXT
REPLACE HYBRID BATTERY TERMINAL BLOCK. Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]
- CHECK FREEZE FRAME DATA
See step 5
Result
Result Proceed to Either of the following conditions is met:
1. All conditions in table 1 are met.
2. All conditions in table 2 are met.A Other than above B Result:
A
REPLACE BATTERY VOLTAGE SENSOR. Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]
Result:
B
See step 6
- READ VALUE USING TECHSTREAM (Hybrid Battery Block Voltage)
See step 6
Result
Result Proceed to All conditions in Table 1, Table 2 or Table 3 are met. A Other than above B Result:
A
REPLACE BATTERY VOLTAGE SENSOR. Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]
Result:
B
See step 7
- CHECK DTC OUTPUT (HYBRID CONTROL)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
- Check for DTCs.
Powertrain > Hybrid Control > Trouble Codes
Result
Result Proceed to P1CFD1E, P302100 or P30211E is not output. A P1CFD1E, P302100 or P30211E is output. B - Turn the power switch off.
Result:
B
See step 10
Result:
A
See step 8
- CHECK TOTAL DISTANCE DRIVEN
- Read the odometer to check the total distance the vehicle has been driven.
Result
Result Proceed to Total distance driven is less than 200000 km (124280 mile) A Total distance driven is 200000 km (124280 mile) or more Current total distance driven - total distance driven when hybrid battery terminal block replaced = less than 200000 km (124280 mile) *1 Other than above B HINT:
*1: If the hybrid battery terminal block has been replaced, use the total distance driven since it was replaced.
Result:
A
REPLACE HV BATTERY. Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]
Result:
B
See step 9
- Read the odometer to check the total distance the vehicle has been driven.
- REPLACE HV BATTERY
Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]
Result
Proceed to NEXT Result:
NEXT
REPLACE HYBRID BATTERY TERMINAL BLOCK. Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]
- REPLACE HV BATTERY
Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]
Result
Proceed to NEXT Result:
NEXT
REPLACE HYBRID BATTERY TERMINAL BLOCK. Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]