Adjustment [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.

SECURE VEHICLE

Fully apply the parking brake and chock a wheel.

WARNING:

Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE REAR CONSOLE BOX ASSEMBLY
Refer to REMOVAL [10/2018 - 07/2022] , or refer to REMOVAL [07/2022 - ]

ADJUST SHIFT LEVER POSITION

NOTE:

Before adjusting the transmission control cable assembly, check that the shift lever position sensor and shift lever are in N.

Slide the adjuster case cover in the direction shown by the arrow.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Adjuster Case
*2	Adjuster Case Cover

Using a precision screwdriver, pull out the lock piece of the adjuster case.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Adjuster Case
*2	Lock Piece

Using your fingers, gently pull the cable rod towards the rear of the vehicle to remove backlash.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Cable Rod

Push in the lock piece of the adjuster case to lock it.

*1	Adjuster Case
*2	Lock Piece

Move the adjuster case cover in the direction shown by the arrow.

NOTE:

If the adjuster case cover is not moved far enough so that the adjuster case cover engages the lock piece, the cable will not be able to lock, and reliable shift operation will not be possible.

*1	Adjuster Case
*2	Adjuster Case Cover

INSTALL REAR CONSOLE BOX ASSEMBLY
Refer to INSTALLATION [10/2018 - 07/2022] , or refer to INSTALLATION [07/2022 - ]