LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Hybrid Transaxle (P711) (Service Information)) >> Shift Paddle Switch >> Inspection [10/2018 - ] >> Procedure

Inspection [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) 
    1. Shift Paddle Switch LH (Transmission Shift Switch Assembly):
      1. Measure the resistance according to the value(s) in the table below.
        Fig 1: Shift Paddle Switch (Transmission Shift Switch Assembly) Connector End View
        GTY772374Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Shift Paddle Switch LH (Transmission Shift Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        1 (SDN) - 2 (ECC) "-" (Down shift) shift paddle switch operated and held Below 13 Ω
        "-" (Down shift) shift paddle switch not operated 1 MΩ or higher
        1 (SDN) - 3 (ECC1) "-" (Down shift) shift paddle switch operated and held Below 13 Ω
        "-" (Down shift) shift paddle switch not operated 1 MΩ or higher

        If the result is not as specified, replace the shift paddle switch LH (transmission shift switch assembly).

    2. Shift Paddle Switch RH (Transmission Shift Switch Assembly):
      1. Measure the resistance according to the value(s) in the table below.
        Fig 2: Paddle Switch RH (Transmission Shift Switch Assembly) Connector End View
        GTY757999Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Shift Paddle Switch RH (Transmission Shift Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        1 (SUP) - 2 (ECC) "+" (Up shift) shift paddle switch operated and held Below 13 Ω
        "+" (Up shift) shift paddle switch not operated 1 MΩ or higher

        If the result is not as specified, replace the shift paddle switch RH (transmission shift switch assembly).