LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Hybrid Transaxle (P711) (Service Information)) >> Shift Lever >> Removal [10/2018 - ] >> Procedure

Removal [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. SECURE VEHICLE 
    1. Fully apply the parking brake and chock a wheel.
      WARNING:
      • Make sure to apply the parking brake and chock a wheel before performing this procedure.
      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
      GTY655852Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE SHIFT LEVER HOLE COVER 
    1. Apply protective tape to the upper console panel sub-assembly at the location shown in the illustration.
      GTY780160Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    2. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the shift lever hole cover from the upper console panel sub-assembly.
      NOTE:

      Be careful not to damage the shift lever hole cover and upper console panel sub-assembly.

  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 

    See step  1

  4. REMOVE REAR CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [10/2018 - 07/2022] , or refer to REMOVAL [07/2022 - ]

  5. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Move the shift lever to N.
    2. Disconnect the transmission control cable assembly from the transmission floor shift assembly.
      GTY798579Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.
      GTY823934Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Lock Nut
      *a Counterclockwise
  6. REMOVE NO. 2 CONSOLE BOX DUCT 

    See step  6

  7. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY 
    1. Disconnect the transmission control switch connector.
      GTY798593Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 clamps to disconnect the wire harness from the transmission floor shift assembly.
    3. Disconnect the shift lock control ECU connector.
      GTY798594Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the clamp to disconnect the wire harness from the transmission floor shift assembly.
    5. Remove the 4 bolts and transmission floor shift assembly from the vehicle body.
      GTY798585Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals