Replacement [10/2018 - 07/2022]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
Refer to REMOVAL [10/2018 - 07/2022]

REMOVE INPUT SHAFT TYPE T OIL SEAL

Using a screwdriver with its tip wrapped with protective tape, remove the input shaft type T oil seal from the hybrid vehicle transaxle assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Protective Tape

NOTE:

Be careful not to damage the input shaft assembly or hybrid vehicle transaxle assembly.

INSTALL INPUT SHAFT TYPE T OIL SEAL

Coat the lip of a new input shaft type T oil seal with a small amount of MP grease.

Using SST and a hammer, install the input shaft type T oil seal to the hybrid vehicle transaxle assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Depth

SST: 09608-04031

Standard Depth

1.9 to 2.7 mm (0.0748 to 0.106 in.)

NOTE:

Do not allow foreign matter to attach to the lip of the input shaft type T oil seal.
Do not install the input shaft type T oil seal at an angle.

INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY
Refer to INSTALLATION [10/2018 - ]