Inspection [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT EV DRIVE MODE SWITCH (COMBINATION SWITCH ASSEMBLY)
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(EV Drive Mode Switch (Combination Switch Assembly))Standard Resistance
Tester Connection Condition Specified Condition 6 (S) - 5 (E) EV drive mode switch being pushed and held Below 1 Ω EV drive mode switch not pushed 10 kΩ or higher If the result is not as specified, replace the EV drive mode switch (combination switch assembly).
- Measure the resistance according to the value(s) in the table below.
- Check illumination.
- Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the EV drive mode switch (combination switch assembly).
OK
Measurement Condition Specified Condition Auxiliary Battery positive (+) → 7 (ILL+)
Auxiliary Battery negative (-) → 10 (ILL-)Illuminates If the result is not as specified, replace the EV drive mode switch (combination switch assembly).
*a Component without harness connected
(EV Drive Mode Switch (Combination Switch Assembly))
- Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the EV drive mode switch (combination switch assembly).
- Check the resistance.