On-Vehicle Inspection [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Hybrid Control / Data List / Accelerator Position Sensor No. 1 Voltage %, Accelerator Position Sensor No. 2 Voltage %.
Powertrain > Hybrid Control > Data List
Tester Display Accelerator Position Sensor No. 1 Voltage % Accelerator Position Sensor No. 2 Voltage % - Read the values displayed on the Techstream.
Standard Voltage
Tester Display Condition Specified Condition Accel Position Sensor No. 1 Voltage Accelerator pedal is fully released 0.5 to 1.1 V Accelerator pedal is fully depressed 2.6 to 4.5 V Accel Position Sensor No. 2 Voltage Accelerator pedal is fully released 1.2 to 2.0 V Accelerator pedal is fully depressed 3.4 to 4.75 V If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.