DTC P0ABF-00: Hybrid/EV Battery Current Sensor "A" Circuit Range/Performance [10/2018 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check for DTCs.

   Powertrain > Hybrid Control > Trouble Codes 

   Result

   Result	Proceed to
   One of the following applies: Only P0ABF00 is output. One or more DTCs other than P0AFC00 and P0AFC96 are also output.	A
   P0AFC00 or P0AFC96 is also output.	B

5. Turn the power switch off.
6. Disconnect the Techstream from the DLC3.

Result: 

B 

GO TO DTC CHART (HYBRID CONTROL SYSTEM). Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2018 - ] 

Result: 

A 

See step  2

See step  3

Result

Result: 

NG 

REPLACE HYBRID BATTERY THERMISTOR. Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

Result: 

OK 

See step  3

Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]

Result

Result: 

NEXT 

See step  4

Refer to PROCEDURE - Step 3

Result

Result: 

NEXT 

See step  5

1. Drive the vehicle for approximately 10 minutes according to the freeze frame data items "Vehicle Speed", "Accelerator Position", "Hybrid Battery Current", "Motor Torque" and "Generated Torque".
   WARNING:

   When performing the confirmation driving pattern, obey all speed limits and traffic laws.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  6

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check for DTCs.

   Powertrain > Hybrid Control > Trouble Codes 

   Result

   Result	Proceed to
   P0ABF00 is not output.	A
   P0ABF00 is output again.	B

5. Turn the power switch off.

Result: 

A 

COMPLETED 

Result: 

B 

REPLACE BATTERY VOLTAGE SENSOR. Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ]