Inspection [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT OIL PRESSURE CONTROL VALVE ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 6.2 to 8.2 Ω If the result is not as specified, replace the oil pressure control valve assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
*a Component without harness connected
(Oil Pressure Control Valve Assembly) - Connect a auxiliary battery positive (+) lead to terminal 1 and a negative (-) lead to terminal 2.
Check that a clicking sound is heard from the oil pressure control valve assembly.
*a Component without harness connected
(Oil Pressure Control Valve Assembly)NOTE:- Check that the auxiliary battery voltage is between 10 and 16 V before performing this test.
- Perform this test within 10 seconds to prevent the coil from burning out.
- Always switch the voltage on and off at the auxiliary battery side, not the oil pressure control valve assembly side.
If the result is not as specified, replace the oil pressure control valve assembly.
- Measure the resistance according to the value(s) in the table below.