LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Lubrication System (M20A-FXS) (Service Information)) >> Oil Pressure And Temperature Sensor >> Removal [10/2018 - ] >> Procedure

Removal [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE REAR ENGINE UNDER COVER RH 
    1. Remove the 2 screws, 6 clips and rear engine under cover RH from the vehicle.
      GTY773759Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE OIL PRESSURE AND TEMPERATURE SENSOR 
    1. Disconnect the oil pressure and temperature sensor connector.
      GTY802654Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 24 mm deep socket wrench, remove the oil pressure and temperature sensor.
      GTY802652Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the oil pressure and temperature sensor is dropped or subjected to a strong impact, replace it with a new one.

scientia non olet · About LEMON Manuals