Installation [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL OIL PRESSURE AND TEMPERATURE SENSOR
- Apply adhesive to 2 or 3 threads of the oil pressure and temperature sensor.
Adhesive
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
*a Adhesive 1344 *b Oil Inlet Port NOTE:- Do not apply adhesive to the oil inlet port of the oil pressure and temperature sensor.
- To prevent contamination by foreign matter, install immediately after applying adhesive.
- Using a 24 mm deep socket wrench, install the oil pressure and temperature sensor.
Torque: 15 N.m (153 kgf/cm, 11 ft.lbf)
NOTE:Do not start the engine within 1 hour of installation.
- Connect the oil pressure and temperature sensor connector.
- Apply adhesive to 2 or 3 threads of the oil pressure and temperature sensor.
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6
- INSTALL REAR ENGINE UNDER COVER RH
- Install the rear engine under cover RH to the vehicle with the 2 screws and 6 clips.