DTC P3193-00: Fuel Run Out [10/2018 - ]: Procedure

1. Check the amount of fuel remaining.

   OK

   There is enough fuel.

   HINT: 

   • DTCs P319000, P319100 and/or P319300 may be output if the vehicle ran out of fuel in the past.
   • If not enough fuel is added, DTC P319000, P319100 or P319300 may be output again. If the engine cannot be started because the vehicle is out of fuel, add fuel until the fuel level warning turns off.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

See step  3

Result: 

NG 

See step  2

1. Add fuel until the fuel level warning turns off.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

5. Turn the power switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
2. Enter the following menus: Powertrain / Engine / Trouble Codes.
3. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P319000 or P319100 is output	B
   DTC P319000 or P319100 and other DTCs are output	C

Result: 

A 

END 

Result: 

B 

GO TO DTC P319000, P319100. Refer to  DTC P3190-00: Poor Engine Power; DTC P319100: Engine does not Start [10/2018 - ]  

Result: 

C 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2018 - 10/2019]  Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2019 - 10/2020]  Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2020 - 08/2021]  Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2021 - ]