LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fuel System (M20A-FXS) (Service Information)) >> Fuel Main Valve >> Installation [10/2018 - ] >> Procedure

Installation [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL MAIN VALVE ASSEMBLY 
    1. Apply gasoline to a new O-ring. Then install the O-ring to the fuel main valve assembly.
      NOTE:

      Make sure that there is no clearance between the fuel main valve assembly and mesh.

      GTY759962Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Fuel Main Valve Assembly
      *a Mesh
      *b Mini-clip
      *c No Clearance
    2. Install the fuel main valve assembly to the fuel suction tube with pump and gauge assembly.
      NOTE:

      Make sure that the O-ring is not cut or pinched during installation.

  2. REMOVE FUEL PRESSURE REGULATOR HOLDER 
    1. Engage the 2 claws and install the fuel pressure regulator holder to the fuel suction tube with pump and gauge assembly.
  3. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to INSTALLATION [10/2018 - ] 

scientia non olet · About LEMON Manuals