LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fuel System (M20A-FXS) (Service Information)) >> FUEL PUMP (for High Pressure) >> On-Vehicle Inspection [10/2018 - ] >> Procedure

On-Vehicle Inspection [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. FUEL PUMP ASSEMBLY OPERATION 
    1. Check fuel pressure.
      1. Connect the Techstream to the DLC3.
      2. Start the engine.
      3. Turn the Techstream on.
      4. Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset / Fuel Pressure (High).

        Powertrain > Engine > Active Test 

        Active Test Display
        Control the Target Fuel Pressure Offset
        Data List Display
        Fuel Pressure (High)
      5. Check that the fuel pressure fluctuates when the target fuel pressure changes.

        HINT: 

        The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.

        If the result is not as specified, replace the fuel pump assembly or fuel delivery pipe.

    2. Check operating sound.
      1. Start the engine.
      2. Using a sound scope, check the operating sound of the fuel pump assembly.

        If no sound can be heard, check the fuel pump assembly, wire harness and ECM.

      3. Stop the engine.
scientia non olet · About LEMON Manuals