LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fuel System (M20A-FXS) (Service Information)) >> FUEL INJECTOR (for Port Injection) >> Removal [10/2018 - 07/2022] >> Procedure

Removal [10/2018 - 07/2022]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 2 FUEL PRESSURE SENSOR 

    Refer to REMOVAL [10/2018 - 07/2022] 

  2. DISCONNECT FUEL TUBE SUB-ASSEMBLY 
    1. Remove the fuel pipe clamp from the fuel tube connector.
      GTY785304Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the fuel tube sub-assembly from the fuel delivery pipe sub-assembly.
      GTY785305Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Refer to PRECAUTION [10/2018 - ]

  3. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY 
    1. Disconnect the No. 5 engine wire connector.
      GTY785216Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and fuel delivery pipe sub-assembly with the 4 port fuel injector assemblies from the cylinder head sub-assembly.
      NOTE:

      Be careful not to drop the port fuel injector assemblies when removing the fuel delivery pipe sub-assembly.

  4. REMOVE FUEL DELIVERY SPACER 
    1. Remove the 2 fuel delivery pipe spacers from the cylinder head sub-assembly.
      GTY818259Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE INJECTOR VIBRATION INSULATOR 
    1. Remove the 4 injector vibration insulators from the cylinder head sub-assembly.
      GTY818257Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE NO. 5 ENGINE WIRE 
    1. Disconnect the 4 port fuel injector assembly connectors.
      GTY785217Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 clamps to remove the No. 5 engine wire from the fuel delivery pipe sub-assembly.
  7. REMOVE PORT FUEL INJECTOR ASSEMBLY 
    1. Pull the 4 port fuel injector assemblies out of the fuel delivery pipe sub-assembly.
      GTY754430Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from each port fuel injector assembly.
      GTY754415Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Attach a tag or label with the corresponding cylinder number to each port fuel injector assembly so that they can be installed to their original locations.
      NOTE:

      Cover the port fuel injector assemblies with plastic bags to prevent damage and contamination.

      GTY766507Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals