Installation [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR ASSEMBLY)

Push the fuel tank pressure sensor (vapor pressure sensor assembly) onto the fuel tank assembly, then install the tube joint clip.

NOTE:

Check that there are no scratches or foreign matter around the connecting parts of the fuel tank pressure sensor (vapor pressure sensor assembly) and fuel suction plate sub-assembly before performing this work.
Check that the fuel suction plate sub-assembly is securely inserted to the end of the fuel tank pressure sensor (vapor pressure sensor assembly).
Check that the tube joint clip is on the collar of the fuel tank pressure sensor (vapor pressure sensor assembly).
After installing the tube joint clip, check that the fuel tank pressure sensor (vapor pressure sensor assembly) cannot be pulled out.

*1	Tube Joint Clip
*a	O-ring
*b	Collar

INSTALL REAR FLOOR SERVICE HOLE COVER
Refer to PROCEDURE - Step 6
INSTALL REAR SEAT ASSEMBLY
Refer to INSTALLATION [10/2018 - 07/2022] , or refer to INSTALLATION [07/2022 - ]