Installation [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL TIMING CHAIN COVER OIL SEAL
- Apply MP grease to the lip of a new timing chain cover oil seal.NOTE:
- Keep the lip free from foreign matter.
- Do not allow MP grease to contact the dust seal.
- Using SST and a hammer, tap in the timing chain cover oil seal.
- SST: 09223-00010
*a 0 to 2 mm Standard Depth
0 to 2 mm (0 to 0.0787 in.) (From the edge of the No. 2 timing chain cover assembly)
NOTE:Do not tap in the timing chain cover oil seal at an angle.
- Apply MP grease to the lip of a new timing chain cover oil seal.
- INSTALL CRANKSHAFT PULLEY ASSEMBLY
Refer to PROCEDURE - Step 47
- INSTALL NO. 1 SIDE RAIL REINFORCEMENT RH
Refer to PROCEDURE - Step 19 [10/2018 - 07/2022] , or refer to PROCEDURE - Step 20 [07/2022 - ]
- INSPECT FOR OIL LEAK
Refer to PROCEDURE - Step 6
- INSTALL REAR ENGINE UNDER COVER RH
See step 66, or refer to PROCEDURE - Step 66
- INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
See step 67, or refer to PROCEDURE - Step 67
- INSTALL FRONT WHEEL RH
Refer to PROCEDURE - Step 1