LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Control System (M20A-FXS) (Service Information) (Hybrid) >> Knock Sensor >> Removal [10/2018 - ] >> Procedure

Removal [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE INTAKE MANIFOLD 

    Refer to REMOVAL [10/2018 - ]

  2. REMOVE KNOCK SENSOR 
    1. Disconnect the knock sensor connector.
      GTY762819Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and knock sensor from the cylinder block sub-assembly.
      NOTE:

      If the knock sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals