Installation [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)
- Apply a light coat of engine oil to the O-ring of the camshaft position sensor.NOTE:
If reusing the camshaft position sensor, be sure to inspect the O-ring.
- Using an 8 mm socket wrench, install the camshaft position sensor to the cylinder head cover sub-assembly with a new bolt.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
NOTE:- If the camshaft position sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.
- Connect the camshaft position sensor connector.
- Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
- INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)
- Apply a light coat of engine oil to the O-ring of the camshaft position sensor.NOTE:
If reusing the camshaft position sensor, be sure to inspect the O-ring.
- Using an 8 mm socket wrench, install the camshaft position sensor to the cylinder head cover sub-assembly with a new bolt.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
NOTE:- If the camshaft position sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.
- Connect the camshaft position sensor connector.
- Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6
- INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 48 Refer to PROCEDURE - Step 48