Installation [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL O-RING
HINT:
Perform this procedure only when replacement of the O-ring is necessary.
- Clean the O-ring groove of the cam timing oil control solenoid assembly.NOTE:
Make sure the O-ring groove is free of foreign matter.
- Install a new O-ring to the cam timing oil control solenoid assembly.NOTE:
Do not damage the O-ring when installing it.
- Clean the O-ring groove of the cam timing oil control solenoid assembly.
- INSTALL CAM TIMING OIL CONTROL SOLENOID ASSEMBLY
- Apply a light coat of engine oil to the O-ring of the cam timing oil control solenoid assembly.NOTE:
If reusing the cam timing oil control solenoid assembly, be sure to inspect the O-ring.
- Using an 8 mm socket wrench, install the cam timing oil control solenoid assembly to the No. 2 timing chain cover assembly with 2 new bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:- If the cam timing oil control solenoid assembly has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or moved out of place when installing the cam timing oil control solenoid assembly.
- Connect the cam timing oil control solenoid assembly connector.
- Apply a light coat of engine oil to the O-ring of the cam timing oil control solenoid assembly.
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6