Inspection [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Cam Timing Oil Control Solenoid Assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 0 °C (32 °F) 6.3 to 7.3 Ω 20 °C (68 °F) 6.9 to 7.9 Ω 40 °C (104 °F) 7.4 to 8.6 Ω If the result is not as specified, replace the cam timing oil control solenoid assembly.
- Measure the resistance according to the value(s) in the table below.
- Stroke Amount Inspection
- Using vernier calipers, measure length (A) and (B) with the shaft of the cam timing oil control solenoid assembly set in the respective positions shown in the illustration.NOTE:
Do not apply auxiliary battery voltage to the terminals of the cam timing oil control solenoid assembly.
HINT:
If the shaft does not extend under its own weight, extend the shaft with your fingers.
*a Shaft Side Facing Down *b Shaft Side Facing Up *c Shaft - Calculate the stroke amount based on the difference of length (A) and (B).
Standard
4.3 mm (0.169 in.) or more
HINT:
Stroke amount = length (A) - length (B)
If the value is not as specified, replace the cam timing oil control solenoid assembly.
- Using vernier calipers, measure length (A) and (B) with the shaft of the cam timing oil control solenoid assembly set in the respective positions shown in the illustration.
- Check the resistance.