Removal [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT PERFORMANCE ROD
Refer to REMOVAL [10/2018 - ]
REMOVE WATER GUIDE PLATE RH
Refer to PROCEDURE - Step 3 Refer to PROCEDURE - Step 3
REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 4 Refer to PROCEDURE - Step 4

REMOVE DASH PANEL HEAT INSULATOR

Remove the 2 nuts and dash panel heat insulator from the vehicle body.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE AIR FUEL RATIO SENSOR

Disconnect the air fuel ratio sensor connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the 3 clamps.

Using SST, remove the air fuel ratio sensor from the exhaust manifold (TWC: Front Catalyst).

SST: 09224-00012

NOTE:

If the air fuel ratio sensor has been struck or dropped, replace it.