Bleeding [10/2018 - ]: Procedure

See step  1

See step  2

1. Fill the reservoir with brake fluid.
   1. Remove the brake master cylinder reservoir filler cap assembly.
   2. Add brake fluid to the reservoir until the fluid level is between the MAX and MIN lines on the brake fluid reservoir.

      Brake Fluid

      SAE J1703 or FMVSS No. 116 DOT 3

      SAE J1704 or FMVSS No. 116 DOT 4

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *a	MAX Line
      *b	MIN Line

2. Bleed the brake system.
   1. Connect the Techstream to the DLC3 and turn the power switch on (IG).
   2. Turn the Techstream on and enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Air Bleeding/AHB-R Utility.

      Chassis > ABS/VSC/TRAC > Utility 

      Tester Display
      Air Bleeding/AHB-R Utility

   3. Select "Brake System Air Bleeding", and bleed air from brake fluid following the instructions on the Techstream.
      NOTE:

      Before following the instructions on the Techstream to perform linear valve offset calibration and ABS solenoid valve offset calibration, release the parking brake. When calibration is complete, immediately apply the parking brake.

   4. After air bleeding, tighten each bleeder plug.

      Torque: 8.3 N.m (85 kgf/cm, 73 in.lbf) 

   5. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [10/2018 - ]

   6. Turn the Techstream off then turn the power switch off.
3. Install the brake master cylinder reservoir filler cap assembly.
4. Inspect for brake fluid leaks.

Refer to PROCEDURE - Step 15 [10/2018 - 07/2022] , or refer to PROCEDURE - Step 14 [07/2022 - ]