LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Electronically Controlled Brake System (Diagnostic Codes (2 Of 2) & Circuit Tests) (Except Hybrid) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model) >> DTC C124E-62: Wheel Speed Sensor Signal Compare Failure [10/2018 - 07/2022] >> Caution / Notice / Hint

Caution / Notice / Hint

NOTE:
  • After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.

    Refer to UTILITY [10/2018 - 07/2022]

  • After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

    Refer to TEST MODE PROCEDURE [10/2018 - 07/2022]

  • After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

    Refer to TEST MODE PROCEDURE [10/2018 - 07/2022]

  • DTC precaution

    Refer to PRECAUTION [10/2018 - 07/2022]

    PROCEDURE TO CLEAR WARNING LIGHTS (WHEN NOT CLEARING DTCS)

    Procedure
    1. Repair or replacement.
    2. Turn the engine switch on (IG).
    3. Drive the vehicle at 11 km/h (7 mph) or more for 1 second or more to clear the warning lights.
scientia non olet · About LEMON Manuals