Brake Warning Light does not Come ON [10/2018 - 07/2022]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Enter the following menus: Body Electrical / Combination Meter / Active Test.
4. Perform the Active Test of the combination meter assembly using the Techstream.

   Refer to DATA LIST / ACTIVE TEST [10/2018 - 07/2022]

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Brake Warning

5. Check the combination meter assembly.

   OK

   The brake warning light / red (malfunction) turns on or off in accordance with Techstream operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to  REMOVAL [10/2018 - 07/2022] 

Result: 

NG 

INSPECT METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2018 - 07/2022]