Inspection [10/2015 - ]: Procedure
- INSPECT POWER BACK DOOR SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)
- Check the operation of the power back door switch (integration control and panel assembly).
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 4 - 14 Power back door switch (integration control and panel assembly) not pushed 1 MΩ or higher 4 - 14 Power back door switch (integration control and panel assembly) pushed Below 100 Ω If the result is not as specified, replace the power back door switch (integration control and panel assembly).
*a Component without harness connected
(Power Back Door Switch (Integration Control and Panel Assembly))
- Measure the resistance according to the value(s) in the table below.
- Check that the switch illuminates.
- Apply auxiliary battery voltage to the power back door switch (integration control and panel assembly) and check that the switch illuminates.
OK
Auxiliary Battery Connection Specified Condition Auxiliary battery positive (+) → 7
Auxiliary battery negative (-) → 12illuminates If the result is not as specified, replace the power back door switch (integration control and panel assembly).
- Apply auxiliary battery voltage to the power back door switch (integration control and panel assembly) and check that the switch illuminates.
- Check the operation of the power back door switch (integration control and panel assembly).