Inspection [10/2015 - ]: Procedure

INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY

Check the operation of the fuel lid lock with motor assembly (motor operation).

Apply auxiliary battery voltage to the fuel lid lock with motor assembly connector, and check that the fuel lid lock with motor assembly operates smoothly as follows.

Auxiliary Battery Connection	Specified Condition
Auxiliary battery positive (+) → Terminal 1 Auxiliary battery negative (-) → Terminal 2	Unlock

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Fuel Lid Lock with Motor Assembly)
*b	Shaft Stroke
*c	Lock
*d	Unlock

If the result is not as specified, replace the fuel lid lock with motor assembly.

Check the operation of the fuel lid lock with motor assembly (fuel lid courtesy switch).

Measure the resistance according the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
2 - 3	Not pushed (OFF)	10 kΩ or higher
2 - 3	Pushed (ON)	Below 1 Ω

If the result is not as specified, replace the fuel lid lock with motor assembly.

Measure the shaft stroke.

Area	Condition	Specified Condition
Shaft stroke	Lock	17.7 +/- 0.4 mm (0.697 +/- 0.016 in.)
Shaft stroke	Unlock	0.9 mm (0.035 in.)

If the result is not as specified, replace the fuel lid lock with motor assembly.