LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> RX 450h Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (Service Information) (1 Of 2) >> Rear Crankshaft Oil Seal >> Removal [08/2016 - 08/2019] >> Procedure

Removal [08/2016 - 08/2019]: Procedure

  1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY 

    Refer to REMOVAL [08/2016 - 12/2017] , or refer to REMOVAL [12/2017 - 08/2019]

  2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY 
    1. Using SST, hold the crankshaft pulley.
      • SST: 09213-70011 
        1. 09213-70020
      • SST: 09330-00021 
      GTY669149Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.
      GTY645305Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FLYWHEEL SUB-ASSEMBLY 
    1. Using SST, hold the crankshaft pulley.
      • SST: 09213-70011 
        1. 09213-70020
      • SST: 09330-00021 
      GTY669149Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 8 bolts and flywheel sub-assembly from the crankshaft.
      GTY645315Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR ENGINE OIL SEAL 
    1. Using a knife, cut through the lip of the rear engine oil seal.
      GTY650816Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Cut Position
      *b Protective Tape
    2. Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.
      NOTE:

      Be careful not to damage the crankshaft.

scientia non olet · About LEMON Manuals