LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> RX 450h Base >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) (Service Information) (1 Of 2) >> REAR COMBINATION LIGHT ASSEMBLY (w/o Rear No. 2 Seat) >> Removal [08/2016 - 08/2019] >> Procedure

Removal [08/2016 - 08/2019]: Procedure

  1. REMOVE TONNEAU COVER ASSEMBLY 

    Refer to PROCEDURE - Step 1 [08/2016 - 12/2017] Refer to PROCEDURE - Step 1 [12/2017 - 08/2019]

  2. REMOVE DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 2 [08/2016 - 12/2017] Refer to PROCEDURE - Step 2 [12/2017 - 08/2019]

  3. REMOVE REAR NO. 3 FLOOR BOARD 

    Refer to PROCEDURE - Step 3 [08/2016 - 12/2017] Refer to PROCEDURE - Step 3 [12/2017 - 08/2019]

  4. REMOVE REAR DECK FLOOR BOX 

    Refer to PROCEDURE - Step 4 [08/2016 - 12/2017] Refer to PROCEDURE - Step 4 [12/2017 - 08/2019]

  5. REMOVE REAR NO. 4 FLOOR BOARD 

    Refer to PROCEDURE - Step 5 [08/2016 - 12/2017] Refer to PROCEDURE - Step 5 [12/2017 - 08/2019]

  6. REMOVE FRONT DECK FLOOR BOX (for LH Side) 

    Refer to PROCEDURE - Step 6 [08/2016 - 12/2017] Refer to PROCEDURE - Step 6 [12/2017 - 08/2019]

  7. REMOVE DECK SIDE TRIM BOX RH 

    Refer to PROCEDURE - Step 7 [08/2016 - 12/2017] Refer to PROCEDURE - Step 7 [12/2017 - 08/2019]

  8. REMOVE REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 8 [08/2016 - 12/2017] Refer to PROCEDURE - Step 8 [12/2017 - 08/2019]

  9. REMOVE REAR DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 11 [08/2016 - 12/2017] Refer to PROCEDURE - Step 11 [12/2017 - 08/2019]

  10. REMOVE REAR SEAT ASSEMBLY LH (for LH Side) 

    Refer to REMOVAL [08/2016 - 08/2019]

  11. REMOVE REAR SEAT ASSEMBLY RH (for RH Side) 

    Refer to REMOVAL [08/2016 - 08/2019]

  12. REMOVE UPPER QUARTER TRIM PAD LH 

    Refer to PROCEDURE - Step 23 [08/2016 - 12/2017] Refer to PROCEDURE - Step 23 [12/2017 - 08/2019]

  13. REMOVE REAR SEAT SIDE GARNISH LH 

    Refer to PROCEDURE - Step 24 [08/2016 - 12/2017] Refer to PROCEDURE - Step 24 [12/2017 - 08/2019]

  14. REMOVE REAR FLOOR FINISH SIDE PLATE LH 

    Refer to PROCEDURE - Step 25 [08/2016 - 12/2017] Refer to PROCEDURE - Step 25 [12/2017 - 08/2019]

  15. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for LH Side) 

    Refer to PROCEDURE - Step 26 [08/2016 - 12/2017] Refer to PROCEDURE - Step 26 [12/2017 - 08/2019]

  16. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side) 

    Refer to PROCEDURE - Step 34 [08/2016 - 12/2017] Refer to PROCEDURE - Step 34 [12/2017 - 08/2019]

  17. REMOVE ROPE HOOK ASSEMBLY 

    Refer to PROCEDURE - Step 27 [08/2016 - 12/2017] Refer to PROCEDURE - Step 27 [12/2017 - 08/2019]

  18. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side) 

    Refer to PROCEDURE - Step 1 [10/2015 - 03/2018] Refer to PROCEDURE - Step 1 [03/2018 - 08/2019]

  19. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for RH Side) 

    Refer to PROCEDURE - Step 2 [10/2015 - 03/2018] Refer to PROCEDURE - Step 2 [03/2018 - 08/2019]

  20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) 

    Refer to PROCEDURE - Step 29 [08/2016 - 12/2017] Refer to PROCEDURE - Step 29 [12/2017 - 08/2019]

  21. REMOVE RECLINING REMOTE CONTROL BEZEL RH (w/o Rear Power Seat System) 

    for RH Side:

    Refer to PROCEDURE - Step 37 [08/2016 - 12/2017] Refer to PROCEDURE - Step 37 [12/2017 - 08/2019]

  22. REMOVE FOLD SEAT SWITCH ASSEMBLY (w/ Rear Power Seat System) 

    for RH Side:

    Refer to PROCEDURE - Step 5

  23. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) 

    Refer to PROCEDURE - Step 39 [08/2016 - 12/2017] Refer to PROCEDURE - Step 39 [12/2017 - 08/2019]

  24. REMOVE REAR LIGHT COVER 
    1. Using a molding remover, disengage the 3 claws as shown in the illustration.
      GTY611718Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Insert Molding Remover Here
      Remove in this Direction
    2. Disengage the 3 claws and guide to remove the rear light cover as shown in the illustration.
      GTY826696Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  25. REMOVE REAR COMBINATION LIGHT ASSEMBLY 
    1. Disconnect the connector.
      GTY645871Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Apply protective tape around the rear combination light assembly as shown in the illustration.
      GTY647410Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    3. Remove the 2 screws.
      GTY645877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light assembly.
      NOTE:

      To prevent the rear combination light assembly from falling when disengaging the pin, lightly hold the rear combination light assembly.

      GTY660489Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Pin
      *b Guide
      Remove in this Direction
    5. Disengage the grommet to remove the rear combination light assembly.
      GTY646226Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals