DTC B1585: USB Device Malfunction [08/2019 - ]: Procedure

1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
2. Turn the power switch off.

   HINT: 

   When this DTC has been stored, it is necessary to turn the power switch off to make it possible for the vehicle to recognize a new device when it is connected.

3. Turn the power switch on (ACC).
4. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

   HINT: 

   • If the malfunction occurred when a USB device was in use, use another USB device for the inspection.
   • If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
   • Refer to System Description for compatible formats and versions.

     Refer to SYSTEM DESCRIPTION [08/2019 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Clear the DTCs.

   Body Electrical > Navigation System > Clear DTCs 

2. Recheck for DTCs and check that no DTCs are output.

   Body Electrical > Navigation System > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE 

Result: 

NG 

REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [08/2019 - ]