LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> RX 450h Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> HEADUP Display System - Diagnostics - Introduction >> HEADUP Display System >> Customize Parameters [08/2019 - ] >> Customize Parameters [08/2019 - ]

Customize Parameters [08/2019 - ]

  1. CUSTOMIZE HEADUP DISPLAY SYSTEM 
    1. Customizing with the Techstream
      1. Connect the Techstream to the DLC3.
      2. Turn the power switch on (IG).
      3. Turn the Techstream on.
      4. Enter the following menus: Customize Setting / Display.
      5. Select the setting by referring to the table below.
        NOTE:

        Be sure to record the current value before customizing.

        Display 

        Tester Display Description Default Setting ECU
        Projection Adjustment (Tilt) Headup display image calibration
        (Tilt calibration)        		 Default 1000000:Clockwise (Hi), 0100000:Clockwise (Mid), 0010000:Clockwise (Lo), 0001000:Default, 0000100:Anti-Clockwise (Lo), 0000010:Anti-Clockwise (Mid), 0000001:Anti-Cloc**cut** Headup display (Meter mirror sub-assembly)
        Master Caution Display Function Function to activate/deactivate the master warning light ON 0:OFF, 1:ON Headup display (Meter mirror sub-assembly)
scientia non olet · About LEMON Manuals