LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> RX 450h Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) (Service Information) (2 Of 2) >> Rear Combination Light Assembly (W/O Rear No. 2 Seat) >> Disassembly [08/2019 - ] >> Procedure

Disassembly [08/2019 - ]: Procedure

  1. REMOVE REAR COMBINATION LIGHT CAP (for LED Type Turn Signal Light) 
    1. for TMMC Made:
      1. Remove the rear combination light cap.
        GTY961275Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        HINT: 

        Use the same procedure for all rear combination light caps.

  2. REMOVE REAR TURN SIGNAL LIGHT BULB (for Bulb Type Turn Signal Light) 
    1. Turn the rear light cord with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.
      GTY663553Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Remove the rear turn signal light bulb from the rear light cord.
  3. REMOVE REAR LIGHT CORD (for Bulb Type Turn Signal Light) 
    1. Turn the rear light cord as shown in the illustration to disconnect them as a unit.
      GTY616892Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Disconnect the connector to remove the rear light cord.
      GTY646222Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR COMBINATION LIGHT BRACKET (for Bulb Type Turn Signal Light) 
    1. Remove the screw and rear combination light bracket.
      GTY646225Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE REAR COMBINATION LIGHT LENS AND BODY (for Bulb Type Turn Signal Light) 
scientia non olet · About LEMON Manuals