Removal [08/2016 - 08/2019]: Procedure

for Single Beam Headlight:

Refer to REMOVAL [08/2016 - 08/2019]

for Triple Beam Headlight:

Refer to REMOVAL [08/2016 - 08/2019]

1. Remove the 3 screws.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the connector cover.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. for Single Beam Headlight without AFS (Adaptive Front-lighting System) :

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Disconnect the connector to remove the headlight light control ECU sub-assembly.
      NOTE:

      If the headlight light control ECU sub-assembly has been struck or dropped, replace it with a new one.

4. for Triple Beam Headlight or Single Beam Headlight with AFS (Adaptive Front-lighting System) :

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Disconnect the 2 connectors to remove the headlight light control ECU sub-assembly.
      NOTE:

      If the headlight light control ECU sub-assembly has been struck or dropped, replace it with a new one.

1. Remove the headlight gasket.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.