LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> RX 450h Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Audio And Visual System (12.3 Inch Display) (Diagnostic Codes & Symptom Tests) >> AUDIO AND VISUAL SYSTEM (for 12.3 Inch Display) >> DTC B1575: GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) [08/2019 - ] >> Procedure

DTC B1575: GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) [08/2019 - ]: Procedure

  1. CHECK DTC 
    1. Clear the DTCs.

      Body Electrical > Navigation System > Clear DTCs 

    2. Turn the power switch off.
    3. Recheck for DTCs and check that no DTCs are output.

      Body Electrical > Navigation System > Trouble Codes 

      OK

      No DTCs are output.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - 07/2020]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [07/2020 - ] 

    Result: 

    NG 

    See step  2

  2. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY ASSEMBLY - RADIO RECEIVER ASSEMBLY) 
    1. Disconnect the J165 multi-display assembly connector.
      GTY959853Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Radio Receiver Assembly)
      *b Front view of wire harness connector
      (to Multi-display Assembly)
    2. Disconnect the J166 radio receiver assembly connector.
    3. Measure the resistance according to the value (s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      J166-2 (GVI+) - J165-1 (GV+) Always Below 1 Ω
      J166-1 (GVI-) - J165-2 (GV-) Always Below 1 Ω
      J166-3 (GVG1) - J165-3 (GVG) Always Below 1 Ω
      J166-2 (GVI+) or J165-1 (GV+) - Body ground Always 10 kΩ or higher
      J166-1 (GVI-) or J165-2 (GV-) - Body ground Always 10 kΩ or higher
      J166-3 (GVG1) or J165-3 (GVG) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  3

  3. CHECK MULTI-DISPLAY ASSEMBLY 
    1. Replace the multi-display assembly with a new or known good one.

      Refer to REMOVAL [08/2019 - ]

    2. Clear the DTCs.

      Body Electrical > Navigation System > Clear DTCs 

    3. Turn the power switch off.
    4. Recheck for DTCs and check that no DTCs are output.

      Body Electrical > Navigation System > Trouble Codes 

      OK

      No DTCs are output.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END (MULTI-DISPLAY ASSEMBLY IS DEFECTIVE) 

    Result: 

    NG 

    REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [08/2019 - ]