LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> RX 450h Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Audio / Video System (Service Information) >> Quarter Trim Speaker (W/ Rear No. 2 Seat) >> Installation [03/2018 - ] >> Procedure

Installation [03/2018 - ]: Procedure

  1. INSTALL QUARTER SIDE SPEAKER ASSEMBLY 
    NOTE:

    Do not touch the speaker cone.

    1. Engage the clip to temporarily install the quarter side speaker assembly.
    2. Install the quarter side speaker assembly with the bolt.

      for Type A 

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

      for Type B 

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      NOTE:

      There are two types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.

      GTY798292Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for Type A
      *B for Type B
    3. Connect the connector.
  2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 18

  3. CONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY 

    Refer to PROCEDURE - Step 9

  4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) 

    Refer to PROCEDURE - Step 20

  5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) 

    Refer to PROCEDURE - Step 31

  6. INSTALL COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR (for LH Side) 

    Refer to PROCEDURE - Step 1

  7. INSTALL NO. 2 AIR CONDITIONING CONTROL ASSEMBLY (for LH Side) 

    Refer to PROCEDURE - Step 1

  8. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side) 

    Refer to PROCEDURE - Step 2 [03/2018 - 08/2019] , or refer to PROCEDURE - Step 1 [08/2019 - ]

  9. INSTALL ROPE HOOK ASSEMBLY (for LH Side) 

    Refer to PROCEDURE - Step 24

  10. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for LH Side) 

    Refer to PROCEDURE - Step 25

  11. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for RH Side) 

    Refer to PROCEDURE - Step 3 [03/2018 - 08/2019] , or refer to PROCEDURE - Step 2 [08/2019 - ]

  12. INSTALL ROPE HOOK ASSEMBLY (for RH Side) 

    HINT: 

    Use the same procedure as for the LH side.

  13. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side) 

    Refer to PROCEDURE - Step 31

  14. INSTALL REAR SEAT SIDE GARNISH 

    Refer to PROCEDURE - Step 26

  15. INSTALL FRONT DECK SIDE TRIM COVER 

    Refer to PROCEDURE - Step 27

  16. INSTALL REAR SEAT OUTER TRACK BRACKET COVER LH (for LH Side) 

    Refer to PROCEDURE - Step 2

  17. INSTALL REAR SEAT OUTER TRACK BRACKET COVER RH (for RH Side) 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 5

  18. INSTALL REAR DOOR INSIDE SCUFF PLATE 

    Refer to PROCEDURE - Step 42

  19. INSTALL REAR DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 43

  20. INSTALL REAR NO. 2 SEAT ASSEMBLY 

    Refer to INSTALLATION [03/2018 - ]

scientia non olet · About LEMON Manuals