Removal [08/2016 - 08/2019]: Procedure

RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
Refer to PROCEDURE - Step 1 [09/2015 - 12/2017] , or refer to PROCEDURE - Step 1 [12/2017 - 08/2019]
REMOVE V-RIBBED BELT
Refer to REMOVAL [08/2016 - ]
REMOVE RADIATOR ASSEMBLY
Refer to REMOVAL [08/2016 - 08/2019]

DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

Remove the bolt and disconnect the discharge hose sub-assembly from the compressor and magnetic clutch.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the O-ring from the discharge hose sub-assembly.
NOTE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

DISCONNECT SUCTION HOSE SUB-ASSEMBLY

Remove the bolt and disconnect the suction hose sub-assembly from the compressor and magnetic clutch.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the O-ring from the suction hose sub-assembly.
NOTE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

REMOVE COMPRESSOR AND MAGNETIC CLUTCH

Disconnect each connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

for Type A:

Remove the 2 bolts and 2 nuts, and separate the bracket.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using an E 8 "TORX" socket wrench, remove the 2 stud bolts.

for Type B:

Remove the 4 bolts and separate the bracket.

Bracket