Adjustment [09/2015 - ]: Procedure

INSPECT REAR DOOR

Check that the clearance measurements of areas a through j are within each standard range.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

STANDARD CLEARANCE

Area	Measurement	Area	Measurement
a	-2.0 to 2.0 mm (-0.0787 to 0.0787 in.)	b	2.1 to 6.1 mm (0.0827 to 0.240 in.)
c	3.65 to 6.65 mm (0.144 to 0.262 in.)	d	-0.5 to 2.5 mm (-0.0197 to 0.0984 in.)
e	4.7 to 7.7 mm (0.185 to 0.303 in.)	f	-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
g	2.0 to 5.0 mm (0.0787 to 0.197 in.)	h	-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
i	-1.2 to 1.2 mm (-0.0472 to 0.0472 in.)	j	2.3 to 4.7 mm (0.0906 to 0.185 in.)

ADJUST REAR DOOR

NOTE:

Make sure to turn the ignition switch off when adjusting door lock strikers.

Using SST, loosen the 4 hinge bolts on the vehicle body and adjust the door position.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Tighten the 4 hinge bolts on the vehicle body after adjustment.
Torque: 32.5 N*m (331 kgf*cm, 24 ft.*lbf)
Loosen the 4 hinge bolts on the door and adjust the door position.
Tighten the 4 hinge bolts on the door after adjustment.
Torque: 32.5 N*m (331 kgf*cm, 24 ft.*lbf)

Disengage the 4 claws to remove the rear door lock striker cover.

Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.

Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.
Torque: 23 N*m (235 kgf*cm, 17 ft.*lbf)

Engage the 4 claws to install the rear door lock striker cover.