LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> RX 350L FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (1 Of 2) >> Power Back Door Control Switch >> Removal [09/2015 - 12/2017] >> Procedure

Removal [09/2015 - 12/2017]: Procedure

  1. REMOVE INSTRUMENT PANEL GARNISH LH 

    Refer to PROCEDURE - Step 4 [09/2015 - 08/2016] , or refer to PROCEDURE - Step 4 [08/2016 - 12/2017]

  2. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 9 [09/2015 - 08/2016] , or refer to PROCEDURE - Step 9 [08/2016 - 12/2017]

  3. REMOVE COWL SIDE TRIM BOARD LH 

    Refer to PROCEDURE - Step 3 [09/2015 - 08/2016] , or refer to PROCEDURE - Step 3 [08/2016 - 12/2017]

  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7 [09/2015 - 08/2016] , or refer to PROCEDURE - Step 7 [08/2016 - 12/2017]

  5. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 8 [09/2015 - 08/2016] , or refer to PROCEDURE - Step 8 [08/2016 - 12/2017]

  6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9 [09/2015 - 08/2016] , or refer to PROCEDURE - Step 9 [08/2016 - 12/2017]

  7. REMOVE DOOR CONTROL SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY) 
    1. Using a screwdriver, disengage the 4 claws and remove the door control switch (integration control and panel assembly) as shown in the illustration.
      GTY653094Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
scientia non olet · About LEMON Manuals