LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> RX 350L FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (1 Of 2) >> Power Back Door Closer Switch >> Inspection [09/2015 - 08/2019] >> Procedure

Inspection [09/2015 - 08/2019]: Procedure

  1. INSPECT BACK DOOR CONTROL SWITCH 
    1. Check the operation of the back door control switch.
      1. Measure the resistance according to the value (s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        4 - 1 Back door control switch not pushed 1 MΩ or higher
        Back door control switch pushed Below 100 Ω

        If the result is not as specified, replace the back door control switch.

        GTY662185Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Back Door Control Switch)
    2. Check that the switch illuminates.
      1. Apply battery voltage to the power back door control switch and check that the LED illuminates.

        OK

        Battery Connection Specified Condition
        Battery positive (+) → 3
        Battery negative (-) → 2        		 LED illuminates

        If the result is not as specified, replace the back door control switch.

scientia non olet · About LEMON Manuals